Notify me of follow-up comments by email. Be respectful, keep it civil and stay on topic. Once you are happy with the space that the refrigerator will go into, put it in front of the space, but with enough of a gap that you can get behind it. Tip Before you get started, check behind your fridge to make sure there is no water line and shutoff valve already there—either extending out of the wall or sticking up through the floor. Below is step-by-step instructions for installing a water line to your fridge. You need to clear out the water tubing to get out any gunk before attaching it to your fridge. The doors are held in place by bolts at the top and bottom, and can be removed by undoing them.

WOMAN | MAN

Running a water line to a refrigerator to supply its ice maker and drinking water dispenser has never been easier. This type of fitting is easy to install and is less prone to leaking than a saddle valve. In most cases, the water line can be run from a kitchen faucet water supply line through the kitchen cabinets and over to the refrigerator. If running the line through the cabinets is not feasible, you might need to run it through the floor and up to where the refrigerator is located. Before you get started, check behind your fridge to make sure there is no water line and shutoff valve already there—either extending out of the wall or sticking up through the floor. An Add-A-Tee adapter is an ideal plumbing fitting for this purpose. It simply threads onto the outlet of a standard fixture shutoff valve, like you have under the kitchen sink. Measure the distance carefully, and buy a supply tube with plenty of length for the job. Although the braided steel is considerably more expensive, the extra strength it provides is well worth the investment. Water leaks can cause significant and very costly damage, so buy the best-quality water supply tube you can. Locate the fixture shutoff valve on the cold water supply line under the kitchen sink. Close the shutoff valve by turning it clockwise until it stops. If it has a lever-type handle, turn the lever so it is perpendicular to the water pipe. Turn on the cold water at the kitchen faucet to relief pressure in the water line. Place a rag or small bucket under the supply valve to catch water draining from the supply tube.

The refrigerator is the easiest of all appliances to install. Fridges today often come with popular extras that require more from you in the way of installation. For this feature, you need to run a water supply line to the back of the fridge.

Fortunately, even the greenest of DIYers can handle this easy job. Turn off the water and then let your sink run to drain what is left in the pipes. Then follow these steps:. Find the cold water supply pipe by fridge hookup the two pipes that supply water to your kitchen sink.

They should run parallel and be fairly close together. If you have a basement, tap into the cold water pipe down there. Doing so gives you easy access to the pipe and from the pipe to the floor area just behind the refrigerator.

Simply cut out a short section of copper and install the compression-fitting valve. Attach the two straps saddles over the cold water pipe and secure them with the supplied bolts and nuts. The shaft or spike of the valve is hollow and pointed so that when you dating in leicester uk or close the handle of the valve completely, the tip of the shaft pierces the copper pipe and water then flows through the hollow center.

Open the valve completely to allow water to flow through the tubing to the fridge. Use an adjustable wrench to tighten the nut to the fitting. Use a spade bit to drill up through the flooring. After all the connections are made, open the water supply and check for leaks.

If it leaks there, carefully remove the fitting and reconnect it, keeping the fitting straight with the threads. If the compression-fitting valve leaks, turn off the fridge hookup and redo the compression fittings. How to Install a Refrigerator with a Dispenser Unit.

WOMAN | MAN